Idiomas disponibles
Idiomas disponibles
When the vehicle is stationary, the device switches on automatically
after approx. 60 seconds, or switches off vibrations generated by
the motor or during driving (automatic switch-off). The device is
only active when the vehicle is parked. This protects the car battery
(Auto-ON-OFF).
Note: Were vehicle or rooms already by Martens or Visited other rodents,
the animals most likely Leave scent marks for district marking. These
smells must be removed before installing the device (in the vehicle at
best by a motor wash).
Electrical connection without permanent function
Please insert the enclosed adapter cable into the device. The device will
now be connected directly to the car battery. The red cable is connected
to the positive pole, the brown cable to the negative pole.
Should your car no longer be in for a long time Operation, please
make sure that the appliance is in this period is disconnected or
switched off.
2. Alternative operation for mobile use: Please open the housing base
with the enclosed screwdriver and insert suitable batteries, please pay
attention to the correct polarity. Close the housing again and switch it on
if necessary to a desired place to be protected. The enclosed adapter
cable is not needed. Please close the plug socket with the plug provided.
Technical data
Battery operation:4 x AA (mignon, not included)
Battery capacity: Up to 8 months (alkaline batteries)
Effective area:
Frequency:
Output frequency: 5 sec. ON and 25 sec. OFF
LED: Chip LED Flash (3x / 1x per minute)
Indications:
Mounting material: 4 cable ties
Switch:
Replacement of the battery
1. Remove the housing cover.
alternatively via 12V car battery
approx. 60m² in closed rooms or 4 metersRadius in the
field
12 - 24 kHz +/- 10%
LED indication (cyclic)
ON-OFF
