Batteries; Lighting Instructions - Agio 98900 Instrucciones De Ensamblado

Make sure the control knob is in the "OFF" position. Unscrew the
push button cap on the ignition module located on the control
panel to access the battery compartment. The ignition module
requires one Alkaline AAA size battery (1.5V). The negative (-)
end goes in first. See Figure 11. Dispose of battery safely.
Battery may explode or leak if charged or disposed of in fire.
Make sure of the polarity. The battery included is mercury and
cadmium free.
CAUTIONS: BATTERY INSTRUCTIONS

Always purchase the correct size and grade of battery most suitable for the intended use.

Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or
batteries of different types.

Clean the battery contacts and also those of the device prior to battery installation.

Ensure the batteries are installed correctly with regard to polarity (+ and -).

Remove batteries from equipment which is not to be used for an extended period of time.

Remove used batteries promptly.
For recycling and disposal of batteries to protect the environment, please check the internet or your local
phone directory for local recycling centers and / or follow local government regulations.
Warning: If these instructions are not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
1.
Open the tank drawer and find the control panel on the left. Make sure the
control knob is in the "OFF" position. See Figure 11. Open the tank valve all
the way.
2.
Push in the igniter button. You will hear a slight clicking sound. With the
igniter button pushed in, push and turn the control knob to the "ON" position.
The fire should light within a few seconds. Once the flame is lit, release the
igniter button and continue to hold the control knob in for 10 to 15 seconds.
Release the control knob. The control knob should pop back out and the fire
remain lit. Note: If the fire does not light, turn the knob to the "OFF" position
and wait five (5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium
(medium flame), or Low (small flame)
4. To turn off the fire pit, turn the control knob to the "OFF" position and turn off
the tank valve.
Jul-01-2015

BATTERIES

LIGHTING INSTRUCTIONS

9
Figure 10
Figure 11
Ignition module