Specifications - Agio 98900 Instrucciones De Ensamblado

IMPORTANT SAFETY INFORMATION ABOUT
An LP-gas cylinder for use with this appliance must have a capacity of 20 lbs. /
9kgs and must be equipped with a Type 1 connector and an OPD (overfill
protection device). Figure 1
The LP-gas supply cylinder to be used must be constructed and marked in
accordance with the specification for LP-gas cylinders of the U.S. Department
of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,
Cylinder, Sphere and Tubes for the Transportation of Dangerous Goods.

The cylinder supply system must be arranged for vapor withdrawal.

The cylinder used must include a collar to protect the cylinder valve.

This appliance shall be used only outdoors in a well-ventilated space and
shall not be used in a building, garage or any other enclosed space.

When this appliance is not is use, the gas must be turned off at the supply
cylinder.

Storage of this appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance.

Cylinders must be stored outdoors in a well-ventilated area out of the
reach of children .Disconnected cylinders must have threaded valve plugs
tightly installed and must not be stored in a building, garage or any other
enclosed areas.
CSA (Canadian Standards Association) certified to ANSI Z21.97•CSA
2.41-2014 "Outdoor Decorative Gas Appliances"
The gas hose is routed through a "U" bolt to prevent the hose from coming in
contact with the burner. DO NOT remove the hose from the "U" bolt.
See Figure 2.
Figure 1
INPUT
Propane Regulator
Pressure
Natural Gas Minimum
Inlet Pressure
Clearances to
combustible surfaces
Jul-01-2015
PROPANE (LP) GAS
Regulator hose
pointed down

SPECIFICATIONS

40,000 Btu/hr
11 in / 2.74 kPa water
column
7 in / 1.74 kPa water column
Sides 24 in / 60.96 cm
4
Figure 2
30,000 Btu/hr Low fire
Top: 72 in / 182.88 cm