Door Replacement; Water Supply Installation; Important - LG LSC22991ST Manual Del Propietário

Remove the
1) Loosen the hinge cover screws and
refrigerator
remove the cover. Remove connection
door
wire.
2) Remove keeper by rotating it clockwise ( )
and then remove the upper hinge by lifting
it up ( ).
3) Remove the refrigerator compartment door
by lifting it up.
NOTE
• Do not remove the grease on the surface of
gasket or hinge.
Pass the
Pass the refrigerator laterally through the
access door as shown in the right figure.
refrigerator

Door replacement

Mount them in the reverse sequence of removal after they pass through the
access door.

Water supply installation

▪ Automatic icemaker operation needs water pressure of 21~121 psi
Before
installation
(1.5~8.5 kgf/cm
3 seconds.)
If water pressure does not reach the rating 21 psi (1.5 kgf/cm
necessary to purchase a separate pressure pump for normal automatic icemaking
and cool water feed.
Keep the total length of the feed water pipe tube within 26 ft (8 m). Be careful for
the tube to avoid being kinked. If the tube is 26 ft (8 m) or longer it may cause
trouble in water feed.
Install the water supply line where it will not be affected by heat.
Connect to potable water supply only.
WARNING
Refer to instructions with water filter kit for installation.
IMPORTANT : Use only new hose-sets supplied whit the appliance and do not
16
2
) (That is, a paper cup (6 oz. or 180 cc) will be fully filled within
reuse old hose-sets.
Installation
Connection
wires
Keeper
Upper
hinge
Lower hinge
Max 2 5 3 4
TEMP Min FRZ 1 1 2 4 3
REF TEMP 5 Max
2
) or below, it is