Bayco Products NightStick TWM-354 Manual De Instrucciones página 8

y Insert the RPS into the upper molded profile of the NS-PIC1 until fully seated.
OPTION 2: USING THE 2-PART VELCRO
The Velcro
®
attached that allow the RPS Pressure Pad Switch to be adhered to any clean
smooth surface of your firearm.
y Prior to installation, use the included Alcohol Prep Pad to clean the application
surfaces of the firearm and the back of the RPS.
y Allow the residual alcohol to fully dry and then remove the backing strip from
one side of the PSA and attach it to the back of the RPS.
y Then repeat that same process to attach the RPS/Velcro Strip assembly to
the firearm.
y Apply even pressure and allow the PSA tape to cure for approximately 24
hours for the best adhesion.
y The Hook and Loop portions of the Velcro may be separated in order to
facilitate temporary removal of the RPS Pressure Pad Switch from the firearm.
OPTION 3: USING A VERTICAL FORE GRIP
Various aftermarket manufactures make Vertical Fore Grips that the Nightstick
RPS Pressure Pad Switch will fit into.
y For example, the TangoDown
Fore Grips allows the RPS Pressure Pad Switch to slide perfectly into the
molded slot of their grip.
y Any other Vertical Fore Grip that has this same profile would work with the
RPS Pressure Pad Switch as well.
OPERATION
The TWM-354/854XL uses the switches on the Remote Pressure Pad for two different
modes of operation.
MOMENTARY-ON MODE
Pressing down and holding the long tape switch will activate the momentary-on mode.
Releasing the tape switch will turn the light off.
CONSTANT-ON MODE
Pressing the small square switch near the end of the RPS until it clicks will activate the
Constant-on mode. NOTE: This switch intentionally requires a lot of force to activate so as
to prevent accidental activation. Pressing the switch until it clicks again will turn the light off.
WEAPON SAFETY
PLEASE BE SURE TO READ, UNDERSTAND AND FOLLOW THESE SAFETY AND
OPERATING INSTRUCTIONS WHEN HANDLING A FIREARM OR THE NIGHTSTICK
TWM WHEN MOUNTED ON A FIREARM. FAILURE TO DO SO CAN BE DANGEROUS
AND COULD RESULT IN SERIOUS INJURY, DAMAGE TO PROPERTY, OR DEATH.
y Use of a firearm under any circumstance is inherently dangerous. SERIOUS INJURY
OR EVEN DEATH may result without proper training in the safe handling of firearms.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
Pads come with 2 strips of Pressure Sensitive Adhesive already
PADS
®
(models BGV-MK46 or BGV-QDSF) Vertical
®
QSG-TWM-354-20