Kichler Starkk Manual De Instrucciones página 8

HANGING THE FAN
Step 5. Remove the hanger ball from the downrod assembly by loosening the set screw,
unscrewing and removing the cross pin and unscrewing the ball off the rod. (Fig.7)
Step 6. Loosen the two set screws and remove the hitch pin and retaining clip from the
coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up through the downrod. Thread
the downrod into the coupling until the hitch pin holes are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 8)
8 | KICHLER.COM
Cross pin
Hanger
ball
Set screw
Downrod
Fig. 7
Supply wires
Downrod
Set screws
Retaining clip
Fig. 8
Set screws
Hitch
pin