Charging The Battery - PNI R11V Manual De Usuario

Transceptor uhf portátil
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
4. CAUTIONS:
- Do not operate this radio without a proper antenna attached
- Refer service to qualified technicians only
- Turn the radio off while parked in a gasoline service station
-
lf it appears that the radio diffuses peculiar smell or smoke, please shut off its
power immediately, then contact with the nearest dealer.
-
Don't keep the radio transmitting too long .lt may be too hot to hurt body or
damage the radio itself.
- Please tum off the radio before entering the inflammable and explosive environment
5. DESCRIERE DISPOZITIV:
Accesorii:
ANTENNA

6. CHARGING THE BATTERY:

The battery pack is not charged at the factory; charge it before use. After repeating the
charge/discharge cycle two or three times, the capacity will increase to best status. You
should charge or change the battery pack if the battery's power is weak.
Caution
- Use the original battery pack only
- Don't short-circuit the terminals or put it in fire.
- Don't attempt to open the unit.
- The ambient temperature should be between O"C to 40°C while charging is in progress
- Always switch OFF the transceiver equipped with a battery pack before charging
- Don't cut off the power or take off the battery during the charging process
- The battery pack life is over when its operating time decreases even though it is fully and
correctly charged. Replace the battery pack.
- Don't recharge the battery pack if it is already fully charged or it will short the life of the
battery.
Charging operations:
NOTE: lf the battery pack is out of power, please charge it.
The charger's indicator shows the charging status below:
- LED red- charging
- LED green- completed
1. Put the DC plug of the transformer into the DC socket of the charger unit.
2. Connected the supplied transformer to the AC jack
3. Slide the battery or the transceiver with a battery pack into the charger.
4. Make sure the battery pack contacts are in contact with the charging terminals, and the
charger LED is on, it begins to charge.
5. The charger light tums to green automatically after charging is completed. After
charging the supplied battery pack for 3 hours, remove it or the transceiver equipped with
it from the charger.
BATTERY
CHARGER
BELT CLIP
10
WRIST STRAP
Tabla de contenido
loading

Tabla de contenido