Shoof Tailwell Manual Del Usuario página 7

How to fit the Torque Arm Extender
On some power drills the Tailwell™ torque arms may be too short to prevent
rotation of the machine. In these cases the nylon Torque Arm Extender tube should
be used.
Fit the Tailwell™ to your drill and adjust the torque arm position to give good access
to the drill trigger. You can make this adjustment by bending the arm up or down
and opening or closing the fi ngers to suit your drill.
The nylon tube is pushed over one of the fi ngers all the way to the end, and then
wrapped around the back of the drill grip, and pushed onto the other fi nger. Cut
any excess tube with a knife if neccessary. (Putting the nylon tube in hot water for
a few moments will help the fi tting.)
The nylon tube will protect the drill from chafi ng on the torque arm and help to
prevent the drill from accidental disconnection from the tail trimmer and falling to
the ground.