Adjusting The Clutch Lever - TOYAMA TDWT80E Manual Del Usuario

Adjusting the belts: Loosen the four locking nuts (Fig. 2) under the engine, in addition to
the throttle grip. Pull the motor to tension the belts V, then tighten the lock nut B and then the nut
C. Check that the tension is adequate before screwing on both nuts. The tension will be correct if
by forcing down the belts in the center between the pulleys, obtain a displacement between 2 and
3 cm.

ADJUSTING THE CLUTCH LEVER

Under normal conditions of use a gap of 0.4 ~ 0.7mm should be maintained between the clutch
bearing (D) and the three pawl (A).
These must be adjusted so that they are all in the same plane of rotation (parallel to the clutch
bearing).
Adjustment: Place the clutch lever in the engaged position.
Loosen the nuts (C) and turn the adjusting nuts (B) to the correct position. Then tighten the three
C nuts to lock the system.
BRAKE SYSTEM ADJUSTMENT
Set the control lever F to the engaged position.
Adjust the distance between the pawl A (Fig. 3) and the clutch roller D (Figure 3) with a
clearance between 0.4 and 0.7 mm (Figure 3). Then adjust the length of the clutch rod and (Figure
A – Safety nut
B – Lock-nut
C – Locking nut
D – Bolt
Fig. 2 - Belt tension adjustment – V
Fig. 3 - Adjusting the clutch lever
26