Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Remove product from the freezer compartment(s) to be defrosted.
2. Turn the main power on/off switch off to defrost all compartments at the same time. If only
defrosting an individual freezer compartment, use the dedicated compartment on/off switch.
3. Allow the freezer to defrost overnight, or until any frost is completely melted.
4. In the morning, or after the frost has melted, soak up any water that may have collected in the
freezer.
5. Spray McD® All Purpose Super Concentrate (HCS) onto a clean dry towel, clean the entire
unit, and wipe dry.
6. Turn the main power on/off rocker switch on, returning the freezer to service.
Cleaning the Hinge Area
1. Once a month, before step five above, remove the three screws holding each plastic cover
over the door hinges.
2. Remove the plastic covers and wash with warm soapy water, sanitize, and wipe dry.
3. Clean the entire cabinet per step five above.
4. Replace the plastic hinge covers and attach with the screws.
5. Turn the power on/off rocker switch on, returning the freezer to service.
Caution: Cleansers, detergents, degreasers, sanitizers or bleaching agents that contain
chlorides or phosphates will cause permanent damage to stainless steel products. The
damage appears as pits, eruptions, voids, small holes, cracks, severe discoloration, or
dulling of the metal finish. Water with high chloride content can also damage stainless steel.
If you are uncertain of your water quality, we recommend you have it tested. This damage is
permanent, costly to repair, and is not covered by the warranty.
Cleaning the Condensing Unit
1. Turn the power on/off rocker switch off.
2. Roll the Grill Side Freezer away from the wall so that the back of the cabinet is accessible and
unplug the unit.
3. From the backside of the cabinet, loosen any dirt particles attached to the fins of the
condensing unit with a wire brush.
4. Clean-up the loosened particles and the fins with a vacuum cleaner.
5. Plug the unit into its power supply and roll the freezer back into place.
6. Turn the power on/off rocker switch on, returning the freezer to service.
Any correspondence pertaining to these cabinets should be directed to the Service Department of
Nor-Lake, Incorporated. Be sure to include the cabinet model number and serial number with
any correspondence.
Nor-Lake, Incorporated
727 Second Street
P.O. Box 248
Hudson, Wisconsin 54016
SERVICE
800-388-5253 Parts/Service
5
800-388-5253 Parts/Service
800-955-5253 Sales
715-386-2323
715-386-6149 FAX
Email: [email protected]
Tabla de contenido
