Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Pressure former
The pressure former ref. 080543 is a practical
machine
with
many
laboratory. For optimum performance and a long-
lasting life, please read the following instructions.
Strong pressurization allows precise molding,
regardless of model trimming, as well as various
thickness (0.5 to 4.0 mm), and size (127, 125, 120
mm) square and round sheet can be used.
Installation
▪ Carefully unpack the unit.
▪ Choose a rigid, flat surface, away from sources
of vibration or heat, for the location of the unit.
Place the unit at a height that allows you to
comfortably handle objects inside the chamber.
▪ Connect the electrical plug to a 220-240 V,
50/60 Hz power supply with an earth connection.
▪ Connect air tube (Ø 8) to the air connection (11)
on the bottom of the back of the body.
▪ Connect power cable to the power supply (14) on
the bottom of the back of the body.
▪ Remove the support fixture (9) and fixed cable
tie.
▪ Rotate the lowing sliding (6) to the lift (90º) to
look to the front.
Operation
▪
Heater:
Sheet heating and softening.
▪ Cylinder: Up & down operation and vacuum.
▪ Pressure: Pressure ejection and model moulding.
6
applications
in
dental
A. Preparation before use
① Connect the power cable to the main unit and
② Connect air tube (Ø8) to air connection of the
the outlet.
③ The factory setting is 5 bar (If the pressure
main unit. (Check pressure gauge operation)
gauge does not work, check the air compressor
④ Rotate the lower sliding in the front direction
in use.)
and place the bead case on the bottom plate of
the main unit.
B. How to use
① Select the sheet that best suits your purpose.
(Temporary, Splint, retainer, bleaching, and so
② Place the model you want to make in the
on)
③ Place a round ○ or square □ type sheet on the
middle of the bead case.
lower sliding to fit the guideline, and then put
④ Press the heater switch on the front top plate.
the upper sliding on.
(The lamp is turned on and the heater is in
⑤ Rotate the lower sliding to the left (90°). At this
standby mode.)
⑥ Wait for the sheet to hit the model height or
time, the heater automatically turns on.
halfway. (Time range is between 50 to 90
seconds. The operating time differs depending
⑦ Rotate the lower sliding to the right (180°).
on the material and thickness.)
⑧ Press the cylinder switch on the front top plate.
(Model location in the center of the body)
(The lamp is turned on and the air case comes
down and presses the upper and lower sliding
⑨ Press the pressure switch on the front top plate.
to create a vacuum standby state.)
At this time, the air is injected into the air case
and the sheet is completely molded into the
model. (The operating time is about 3 to 5
minutes depending on the material and
thickness.)
EN
Tabla de contenido
