Horizon Global 24967 Instrucciones De Instalación página 5

4. Remove tie down bracket - Using a 19mm socket, remove (2) bolts
from tie down bracket on driver's side. Bolts to be used for hitch
installation. Return tie down bracket to vehicle owner.
5b. Trim underbody panel – using a tape measure, marker and utility knife,
measure, mark, and trim the underbody panel as shown is Figure 2 and 3.
©2017, 2018 Horizon Global™ Corp - Printed in Mexico
Side of
Underbody
panel
Figure 2
5a. Trim underbody panel – using a tape measure, marker and utility knife,
measure, mark, and trim the underbody panel as shown is Figures 2 and 3.
Area to Trim
6. Install hitch – raise hitch into position, raising the driver's side of hitch
into position first, position bracket above carbon canister hoses, then
raise the passenger's side into position. See Figure 1.
Sheet 5 of 21 24967NP
L C
of Vehicle
1-3/4"
5-1/2"
2-1/2"
Rear
Figure 3
1-24-18 Rev. C
4"