Horizon Global 24967 Instrucciones De Instalación página 3

Frame rail
Authorized Drawbar Kit:
3593
Drawbar must be used in the
RISE position only.
Figure 1
Tie down bracket
Return to owner
Always wear SAFETY GLASSES
when installing hitch
1. Lower muffler – Using an exhaust hanger removal tool, lower muffler by removing (1) rearmost rubber hanger, and (1) forward rubber hanger. A spray a lubricant or soapy water on rubber hangers makes
them slide off metal pins more easily. NOTE: Be sure exhaust is supported before removing rubber hangers.
2. Remove exhaust hanger bracket – Using a 19mm socket, remove (2) bolts from exhaust hanger bracket on passenger's side. Save exhaust bracket and bolts to be reused for hitch installation.
3. Remove underbody panel – using a flat head screw driver and a 10mm socket, remove (6) plastic push-pin rivets, (1) hex nut, and unscrew (4) threaded panel fasteners from bottom of panel.
4. Remove tie down bracket - Using a 19mm socket, remove (2) bolts from tie down bracket on driver's side. Bolts to be used for hitch installation. Return tie down bracket to vehicle owner.
5. Trim underbody panel – using a tape measure, marker and utility knife, measure, mark, and trim the underbody panel as shown in Figures 2 and 3.
6. Install hitch – raise hitch into position, raising the driver's side of hitch into position first, position bracket above carbon canister hoses, then raise the passenger's side into position. See Figure 1.
7. Reinstall fasteners - Loosely reinstall the (4) factory M12 bolts (and exhaust hanger bracket on passenger's side) into existing weldnuts in frame. NOTE: The hitch is sandwiched between the exhaust
hanger bracket and frame. See Figure 1.
8. Tighten all M12 factory bolts with torque wrench to 76 Lb.-Ft. ( 103 N*M)
9. Raise muffler back into position and reattach all rubber hangers removed in step 1.
10. Reinstall the underbody panel using (4 of 6) push-pin rivets, (4) threaded fasteners, and (1) hex nut.
11. Secure Fascia tabs -Using (2) cable ties provided, secure (2) rear fascia tabs to bottom of hitch bracket. Trim excess ends of cable ties. See Figure 4.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed
and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems
of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2017, 2018 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 24967, 77967, CQT24967
Side of
Underbody
panel
(Sold Separately)
Existing weldnuts
(4) Places
Factory
Exhaust hanger
M12-1.25 Bolts
Bracket
(4) Places
Proper torque is needed to keep the hitch secure to the vehicle when towing.
①
Qty. (2)
Cable Tie
Fascia Tabs
Figure 2
Area to Trim
Rear
Figure 3
Sheet 3 of 21 24967NP
Fastener Kit: 24967F
Cable Tie
Figure 4
L C
of Vehicle
1-3/4"
5-1/2"
4"
2-1/2"
1-24-18 Rev. C