Installing The Printer - OHAUS SF40A Manual Del Usuario

• CP437 MS-DOS Latin US: Covers Western
European languages such as English, German,
French, Spanish and Italian.
• CP852 MS-DOS Latin2: Covers Central
European languages that use Latin script such
as Polish Bosnian, Czech, Hungarian, Croatian,
Romanian, Serbian and Slovak.
• CP860 MS-DOS Portuguese: Covers Portuguese
language.
f. Balance Features:
1. Enable/Disable a function: 0/T, Statistics,
Totalization.
2. Printer connection status: LED light will either
blink or stay lit.
• Balance Feature Enabled: 0/T, Statistics
and Totalization functions are enabled. The
printer connection status LED light will blink
if the connection with balance is lost.
• Balance Feature Disable: 0/T, Statistics,
Totalization functions are disabled. The
printer connection status LED will be lit even
if the connection with balance is lost.
g. 0/T Setting: Set up the function of the 0/T button.
• Perform Zero: Perform Zero function when
pressing the button.
• Perform Tare: Perform Tare function when
pressing the button.
h. Baud rate, Data bits, Parity, Stop bits, Flow
Control: Set the parameters of RS-232 setting.
• Settings should be the same as the scale to
be connected. For the scale RS-232 settings,
please see scale manual.
Factory Reset
Get Status
Save Status
8. Click the Save Status button to save the setting and
click Exit to finish the setup.
PAGE 3 OF 33
SETUP CONTINUED
Reset printer to factory default
setting.
Get current setting from the
printer.
Save the setting to the printer.
PRINTER SETUP USING PRINTER ONLY
1. Connect the printer to the main power supply.
2. Use the main switch <I/O> to power on.
3. Press and hold the
the printer will print "----------Menu-------".
• Press to choose which item to change.
• Press to change the parameter.
• Press and hold
• Press to exit without saving.
The printer will print the content to show the result of
every operation. See Operation for total menu structure.
(See pages 5-8)

INSTALLING THE PRINTER

CONNECTING THE PRINTER TO THE SCALE
Before connecting, make sure the scale and printer
have the same RS-232 parameter setting. For scale
Baud rate settings, see Recommended Settings on
pages 6-7.
1. Attach interconnecting cable to the printer interface
of the scale and to the printer.
2. Switch the scale on.
SWITCHING THE PRINTER ON
1. Connect printer to the main power.
2. Use main switch <I/O> to power on. (See Figure 5)
Figure 5
3. RS-232 interface only: The pilot lamp will flash until
scale is connected. If pilot lamp continues to flash,
see Troubleshooting on pages 9-10.
button to enter the menu list,
to save and exit.
<I/O>
Pilot Lamp
0721 IH-8093