Ruby DN-50EY Manual Del Usuario página 12

Stand-by: Contains startup, shutdown.
.
Sleep mode: After entering sleep mode
to run with mínimum wind speed.
Mode selection
Normal, Continuous, Strong, Fan
Normal dehumidification mode:
this mode, wind speed and humidity is
adjustable.
Continuous dehumidification mode:
On this mode, compressor run, wind
speed is low and humidity is not
adjustable.
Strong dehumidification mode:
On this mode, wind speed is high for
dehumidifying strongly and humidity is
not adjustable.
Frosting test:
The indicator light on when defrosting operates, the compressor stop working and fan still working.
Tank full test:
When tank is full of water, the indicator light flashing and buzzer sounds, it can be work normal after empty
the water of tank.
Continuous dehumidification
At first, gently knock the lid
off with a hammer.
Lid
Hammer
This method is suitable for close or downward drainage.
IV. MAINTENANCE
Turn off the unit and disconnect the power plug before cleaning or other routine
maintenance.
Do not remove the float lever from the water tank.
When the unit is not in use for a long time.
1. Unplug the unit, bundle the power cord, and hang the bundled cord at the back of the unit as shown.
2. Empty the water out of water tank, wipe the tank with cloth and replace in position.
3. Clean the air clean filter.
4. For storing, stand the unit upright and avoid the exposure to the direct sunlight.
Attention
To avoid malfunction or abnormal sound, keep the unit upright.
Fan mode: On this mode, the fan
running, compressor stop.
Speed: According to the wind speed
key to select the current wind speed:
The wind speed key is only effective
in the normal dehumidification mode
and the fan mode.
Setting: Set humidity, set the range
of 10%-90% (1% each time)
On
Timer: Timing can be set from within
0-24 hours
Child lock: Long press 5 seconds to
lock. Again long press 5 seconds to
unlock..
DN-50EY
Insert the tube into the
hole released from the
plastic cap.
The tube must be 10 mm
in diameter.
12