Tabla de contenido
Contents • Contenu • Inhalt • Inhoud • Contenidos • Innehåll • Innhold • Sisältö • Indhold • Indice • Conteúdo
Zawartość • Περιεχόμενα • İçindekiler • Tartalom • Obsah • Содержание • Sisukord • Saturs • Turinys
x1
Assembly • Assemblage • Montage • Samenstelling • Montaje • Montering • Montering • Kokoaminen • Montering
Montaggio • Montagem • Montaż • Συγκρότημα • Montaj • Összeszerelés • Sestava • Сборка • Koostamine
1
2
5
GB
Thank you for choosing a Hozelock quality sprayer, you can be
assured of many years of reliable service from this product.
Instructions & Warnings
• This sprayer is intended for use with water-based solutions
of: insecticides, fungicides, weedkillers and fertilizers.
• Always follow the chemical suppliers instructions, as well as
the instructions supplied with this sprayer.
• Make sure all nuts are screwed hand tight before use.
• If the sprayer has been used with chemicals, discard safely
any unused solution after use.
• Always use eye protection when replacing valves, seals or
springs.
• Before carrying out any maintenance on this sprayer
it is essential to depressurise the bottle, by lifting the
pressure release knob.
Always wear protective clothing, goggles,
face mask and gloves.
Avoid inhaling spray mist.
Avoid skin contact with chemicals.
Always work in a well ventilated area.
Take care to protect children, pets & fish from exposure to
chemicals.
Always wash hands thoroughly after use & especially
before eating.
Always wash any contaminated clothing.
Cuprins • Зміст • Vsebina
x1
Montāža • Surinkimas • Ansamblu • Монтаж • Sestav
3
6
x1
x1
4
7
Seek medical attention if spray gets in your eyes or you
develop any symptoms after spraying.
Do not spray near food or food preparation areas. When
spraying crops, pay particular attention to the chemical
manufacturers advice on time before crops can be eaten.
Do not spray any solvent e.g. White spirit.
Spray only thin watery solutions; thicker mixtures will clog
the nozzle.
Powdered chemicals can be sprayed successfully if they
are completely soluble in water. If they are not, or the
solution tends to settle, spraying can still be successful if
the mixture is continually agitated.
If the material to be sprayed contains sediment, strain the
liquid into the sprayer bottle.
Do not over pressurize the bottle. The pressure release
valve is designed to release excess pressure, and must not
be tampered with, or forced to remain closed.
Winter use – drain liquid from all parts and loosen pump
assembly.
Annual maintenance – At least once per year thoroughly
clean the whole sprayer and apply silicone grease to all
moving parts & seals. Test with water, and if any washer or
seal has perished it must be replaced.
This sprayer is made from many different types of plastic,
and although the liquid you wish to spray may be packed
in plastic, this does not guarantee it will not damage the
sprayer. If you have any doubt about compatibility
contact Hozelock consumer services.
When filling the sprayer ensure that the maximum fill level
is not exceeded.
x1
Tabla de contenido
