Hkoenig gino536 Manual De Instrucciones página 7

CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas and fitted with the
appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator
and the appliance with hose clips/nuts. This pizza oven is set to operate a 28 mbar regulator with
butane gas, and a 37mbar regulator with propane gas, and a regulator with butane/propane mixture at
37mbar, and a regulator with butane/propane mixture at 50mbar and a regulator with butane/propane
mixture at 30mbar. Use a suitable regulator certified to BSEN 16129: 2013. Please consult your LPG
dealer for information regarding a suitable regulator for the gas cylinder.
BEFORE USE PLEASE CHECK FOR LEAKAGE!
Never check for leaks with a naked flame, always use a soapy water solution.
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are
secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak, which must
be rectified before use.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your gas dealer.
In the event of gas leakage, turn off the gas supply.
REGULATOR AND HOSE
Use only regulators and hose approved for LPG at the above pressures (See page 2). The life
expectancy of the regulator is estimated as 10 years. It is recommended that the regulator is changed
within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before
operating the appliance.
The hose used must conform to the relevant standard for the country of use. The length of the hose
must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is not
obstructed, kinked, or in contact with any part of the pizza oven other than at its connection.
The hose should comply with the standard EN16436.
The hose should not be twisted or kinked when attached to the gas cylinder.
Flexible metal or rubber pipe, used to connect the appliance with the LPG cylinder must be changed
within the prescribed intervals and according to the National Rules in force
No part of the hose should touch any part of the appliance.
STORAGE OF THE APPLIANCE
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from
the appliance. When the appliance is not to be used for a period of time it should be stored in its original
packaging in a dry dust free environment.
GAS CYLINDER
The appliance can be used with any gas cylinder of weights between 4.5KGS and 15 KGS butane and
3.9 KGS to 13 KGS propane. The gas cylinder should not be dropped or handled roughly! If the
appliance is not in use, the cylinder must be disconnected. Replace the protective cap on the cylinder
after disconnecting the cylinder from the appliance.
7/7