Craftsman CMXGZBF7124533 Manual De Instructiones página 5

ASSembLy
Step 1: (fig. 1)
1. IAssemble the axle clamps (U) and four 5/16" hex nuts
(SEMS) (E) to the factory installed bolts in the frame
tubes. Do not tighten yet.
Fig. 1
FACTORY
INSTALLED
BOLT
AXLE
CLAMP (S)
Step 2: (fig. 2)
1. Slide the axle through the two axle brackets.
2. Assemble a long spacer (R), a short spacer (Q), a 3/4"
washer (H), a wheel (valve stem facing out) and another
3/4" washer (H) onto the axle. Assemble a cotter pin (M)
through the end of the axle. Repeat on other end.
3. Tighten the four nuts which fasten the axle clamps to
the frame tubes. Refer back to figure 1.r
Fig. 2
1/8" x 1-1/2"
COTTER PIN (M)
5/16" SEMS NUT (E)
SPACER (R)
SPACER (Q)
3/4" WASHER (H)
Step 3: (fig. 3)
1. Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts (A)
and 5/16" nylock nuts (F). Do not tighten yet. Repeat for
other side.
Fig. 3
Step 4: (fig. 4)
1. Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts (B) and 5/16" nylock nuts (F). Do
not tighten yet.
2. Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts (F).
Position each bolt behind a cross bolt in the hitch arms.
Do not tighten yet.
3. Tighten all nuts assembled in steps 3 and 4 at this time.)
Fig. 4
5/16" x 1-1/4"
HEX BOLT (B)
5/16" NYLOCK
NUT (F)
ENglISh
5/16" NYLOCK
NUT (F)
5/16" x 2"
HEX BOLT (A)
HITCH ARM
5/16" x 2"
HEX BOLT (A)
5/16" NYLOCK
NUT (F)
3