Cold Weather Operation; Adjusting The Nailing Depth; Nail Indicator - Powermate VX BNCS2P Manual Del Usuario

SEQUENTIAL FIRE
1. Position the nail outlet on the workpiece with finger off
the trigger.
2. Depress the safety firmly until it is completely depressed.
3. Pull the trigger to drive a nail
4. Remove finger from the trigger.
To continue nailing a separate location, move the tool along
the wood, repeating steps (2-4) as required.
CONTACT FIRE
WARNING
To avoid double firing or accidental firing due to recoil.
• Do not press the tool against the wood with excessive
force.
• Separate the tool from the wood as it recoils after nailing.
1. Pull the trigger with the tool off the workpiece.
2. Depress the safety against the workpiece to drive a nail.
3. Move the tool along the workpiece with a bouncing
motion. Each depression of the safety will drive a nail. As
soon as the desired number of nails have been driven,
remove finger from the trigger.
NOTE:
• Always handle nails and package carefully. If nails are
dropped, collating bent may be broken, which will cause
mis-feeding and jamming.
• After nailing:
1. Disconnect air hose from the tool.
2. Remove all nails from the tool.
3. Supply 5-10 drops of pneumatic tool lubricant into
the air plug on the tool.
4. Open the petcock on the air compressor tank to drain
any moisture

COLD WEATHER OPERATION

WARNING
DO NOT USE A FROZEN TOOL. Allow tool to thaw before
using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool
damage.
When using the tool in cold conditions the tool will cycle
slower than usual while driving the first nails. The cycle rate
will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.

ADJUSTING THE NAILING DEPTH

WARNING
Disconnect the tool from the air source before making
adjustments. Such precautionary safety measures reduce
the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from the tool.
3. Adjust tool driving depth:
• T o reduce the nail depth , turn the adjustment knob
counter clockwise (FIG 10).
• T o drive the nail deeper, turn the adjustment knob
clockwise (FIG 11).
4. Reload nails as described in the "Loading Nails" section
of this manual.
5. Reconnect the tool to the air supply.
FIG. 10
Too Deep
Turn the adjustment knob counter clockwise
FIG. 11
Too Shallow
Turn the adjustment knob clockwise
ADJUSTING THE EXHAUST
The direction of the exhaust vent can be changed by turning
the top cover (FIG 12).
FIG. 12

NAIL INDICATOR

The red indicator bars are used to show when the tool needs
to be reloaded (FIG 13). When the tool is loaded with a nail
strip, the red indicator bars will no longer be visible in the
indicator window. As then nails strip is consumed, the red
indicator bars will start to become visible. The tool should be
reloaded when the red indicator bar is half way exposed in
the indicator window.
7 - ENG LISH
Flush
Flush