Control Panel; Error Codes - Black and Decker BDT20WTB Manual De Usuario

SET UP & USE

CONTROL PANEL

Clean Filter
LED Indicator
Filter
Button
ERROR CODES: (Will appear in the digital humidistat display)
E1: The temperature sensor on the discharge pipe may be faulty and may need to
be changed.
E2: The temperature sensor on the heat exchanger may be faulty and may need
to be changed.
E3: If the E3 error code is shown on the digital display, check to make sure the
room temperature is below 90˚F. If the room temperature is too high, place
the dehumidifier in a location where the room temperature is below 90˚F for at
least 2 hours before operating again. If the E3 code appears again, contact the
customer service department.
EH: The humidity sensor may be faulty and may need to be changed.
P1 (Model BDT50PWTB): Bucket is not in the proper position. Make sure the
bucket is in place and securely seated for the dehumidifier to operate. If error
code reappears after adjusting the bucket, please contact the customer service
department.
E5 (Model BDT50PWTB): The pump drainage kit may not be installed before
start pump function or users use non-standard drainage pipes. (Manufacturer's
original pipe), or the drain cover is not tightened, or the rubber washer is
missing, or poor connection between drain pipe and drain cover.
If any of these error codes appear and remain in the display, please contact the
customer service department as listed on page 18 of the user manual.
Page 6
Pump LED
Indicator (Model
BDT50PWTB)
High Fan Speed
LED Indicator
P
Increase Room
Humidity Level
Fan
Speed
Button
Digital
Humidistat
Display
Timer OFF
LED Indicator
P
Decrease Room
Humidity Level
Pump Button
(Model
BDT50PWTB)
Timer ON
LED Indicator
Continuous
Drain LED
Indicator
Power Button
Timer Button
Bucket Full
LED Indicator