Reese 63134 Instrucciones De Montaje página 4

PROPER USEAGE
LOADING INSTRUCTIONS:
1. Load bicycle closest to vehicle first. Start by removing bail pin and rotating both side tubes downward as shown in Fig 5.
2. Load bicycle into wheel cradles (A, B). Adjust wheel cradles to appropriate position. Ensure tire is well supported at both ends of
each wheel cradle. Tighten knob on each wheel cradle to prevent movement. Fig 6.
3. Rotate center tube to vertical position and lock with bail pin. Lower frame hook down over bicycle frame and apply downward
pressure to bicycle and frame hook. Tighten knob and ensure there is no movement of bicycle. Fig 7.
4. Loop wheel cradle straps over wheels and secure. Fig 8.
WARNING – Failure to use wheel cradle straps may result in bike falling off carrier during use.
5
7
Remove this
bail pin
Side Tubes
Tighten
Knob
Lock Bail Pin
6
8
PAGE 4 63134_IN Rev A • Questions? (800) 234-6992 • ReeseBrands.com
Tighten
Knob
Tighten
Knob
Wheel Cradle
Strap