TRES Grifería Instrucciones página 15

ow if the temperature is above 50°C. Press the ON/OFF button to restart. System limited to 46°C maximum temperature. Minimum temperature 25°C. The equipment is capable of closing active outlets if the power supply fails.
• Operating mode.
- The system starts at 38 °C by default.
- The selected temperature level is indicated numerically and on a colour scale: Blue: 25°C - 33°C / Fuchsia: 34°C - 40°C / Red: 41°C - 46°C
- If 3 seconds go by after selecting a temperature and an outlet is active, the real temperature will blink on-screen until the preselected
temperature is reached.
- Opening and closing outlets does not change the preselected temperature.
automatically when it has been running for 15 minutes.
: Press the ON/OFF button.
- The system will close if an outlet is active.
.
1- Clean the product periodically with water or pH neutral liquid detergent.
2- Rinse with clean water and dry with a soft cotton cloth.
3- Do not use acidic or abrasive detergents.
PROBLEM
Screen Indicator: E1
S r c e e n n I i d a c o t : r 2 E
Screen Indicator: E3
Screen Indicator: E4
Screen Indicator: E5
The hot water does
not reach the selected
temperature.
The cold water
temperature is higher than
the selected temperature.
Touch buttons fail to
operate.
ow or
temperature.
No water comes out.
except the ON/OFF button.
MAINTENANCE
POSSIBLE CAUSE
Connection failure between screen and control
unit.
h T r e m s o a t c i t o c n r t l o a f u l i . e r
Temperature probe reading failure.
Thermostatic control failure when maximum
temperature is reached.
Safety stop. Temperature above 50°C.
The hot water is not between 55°C and 65°C.
The hot water pressure is lower than the cold.
The cold and hot pipes have been reversed.
The thermostatic cartridge is dirty.
The cold water pressure is lower than the hot.
The cold and hot pipes have been reversed.
The thermostatic cartridge is dirty.
N o p o w . r e
Very imbalanced cold/hot water pressures.
Malfunction in the cold or hot water supply
The anti-scalding system has been activated
S s y e t m m l a u f n t c o i n
SOLUTION
Secure connections.
N t o y f i e T h c
Notify Technical Support.
Disconnect and reconnect the system / Notify
Technical Support.
Disconnect and reconnect the system / Notify
Technical Support.
Increase the water inlet temperature.
Increase the hot water pressure or reduce the cold.
Reverse the pipes.
Notify Technical Support.
Increase the cold water pressure or reduce the hot.
Reverse the pipes.
Notify Technical Support.
C h e k c p o w
Equalise the pressures; 3 bar is recommended.
Check the water supply
Disconnect and reconnect the system / Notify the
technical service centre
N t o y f i h t e e t
- 15 -
ow. The safety system cuts the
n c i l a u S p p o . t r
lter.
lter.
r e u s p p . y l
lters.
h c i n a c s l r e i v e c e c t n . e r