cancelling associations
TOTAL
- Hold the aerial's button down for 20s
- The aerial's red led will fl ash quickly 5
times
- The association between the aerial and
all previously connected devices is can-
celled
- The aerial's red led will go out after can-
cellation is completed
- To complete the cancellation on the de-
vice connected with the aerial, proceed
as follows:
• Room sensor: set parameter rf04 to 0
• Zone modules
hold the button down for 20s or until
the red led stays on
LED
STATUS
OFF
GREEN
ON
OFF
Slow fl ashing
RED
Rapid fl ashing
ON
SELECTIVE
- Hold the aerial's button down for 10s
- The red led will start fl ashing quickly
- Press the button used for the associa-
tion procedure on the device you wish
to cancel, or set parameter rf04 on the
room sensor to 0
- The association between the aerial and
device is cancelled
- The aerial's red led will turn off
- To complete the cancellation on the de-
vice, proceed as follows:
DIAGNOSTICS
controller not powered on
controller powered on
device associated or stand by
aerial in association mode after button held down for 3s
aerial in selective cancellation mode after button held down for 10s
Aerial not associated
• Room sensor: set parameter rf04 to 0
• Zone modules
hold the button down for 20s or until
the red led stays on
GB - 15