Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Wiring
WARNING! Only connect the unit to a 12-volt power supply with proper grounding.
Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat-
tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The
VM9214 uses one 15 amp fuse, located in the black fi lter box in-line with the main wire harness.
Final Installation
After completing the wiring connections, turn the unit on to confi rm operation (ignition switch must be on). If
unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off
the ignition switch and proceed with fi nal mounting of the chassis.
Connect wiring adapter to existing wiring harness.
1
Connect antenna lead.
2
Carefully slide the radio into the mounting sleeve, making
3
sure it is right-side-up, and secure with the original 4 screws.
Attach one end of the perforated support strap (supplied) to
4
the screw stud, which is screwed into the threaded insert on
the back of the unit, using the hex nut provided. Fasten the
other end of the perforated strap to a secure part of the
dashboard either above or below the radio using the screw
and hex nut provided. Bend the strap to position it as
necessary.
Replace any items you removed from the dashboard.
5
ISO-DIN Installation
Remove mounting sleeve brackets.
1
Remove trim ring.
2
Mount factory brackets on new radio using existing screws
3
from old radio.
Slide radio chassis into dash opening and secure.
4
Re-install dash panel.
5
CAUTION! The rear of the radio must be
supported with the strap to prevent dam-
age to the dashboard from the weight of
the radio or improper operation due to
vibration.
NOTE: For proper operation of the CD/
DVD player, the chassis must be mounted
within 20° of horizontal. Make sure the unit
is mounted within this limitation.
EJE CT
A / V
INPU
T
Remove Mounting
Sleeve Brackets
3
EJE CT
A / V
INPU
T
EJE
CT
A / V
INPUT
Tabla de contenido
