Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. Remote Control Operation.
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
button - controls LIGHT function: turns light
ON/OFF when tapped quickly. Pressing and
holding button down for more than 0.7 seconds
converts it into a dimmer. Auto resume capability
keeps light at same brightness level as the last
time it was turned off.
13. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the different fan speed buttons on
remote control. Test the light ON/OFF function
with the
button on the remote control. Test
dimmer function by holding down the
button for more than 2 seconds. If the remote
control operates all of the functions of the fan
and light, battery has been installed correctly
(diagram 1). If fan and/or light does (do) not
function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch (located on top of motor housing).
Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in
the middle position (diagram 4), fan will not
operate.
reverse switch
diagram 1
diagram 2
diagram 3
page 9
yoke cover
motor
housing
diagram 4
Capítulos
Tabla de contenido
