Maintenance And Cleaning; Troubleshooting Guide - PYD Electrobombas POOL Serie Manual De Instrucciones Y Mantenimiento

INSTRUCTION MANUAL AND MAINTENANCE
SERIES POOL / POOL2

MAINTENANCE AND CLEANING

Our pumps do not require any special maintenance or programming.
If the pump will be idle for a long period of time, it is recommended to disassemble, clean and store
it in a dry, well-ventilated place.
Pump can be automotive empty water after correct installation.
When the pump needs to clean:
(1) Filled with water to the level position of the nozzle,
(2) operating 2-3mimute,
(3) exhausting water off after engine stop.
PROBLEMS
PUMP DOES
NO TURN
PUMPS ARE NOT
PUMPING
PROPERLY
www.proindecsa.com / [email protected]
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSE
NO POWER
TO PUMP
BLOCKAGE OR
LEAK
LOW VOLTAGE
INSTALACIÓN
CORRECTIONS
-Incoming power to the pump?
-Is circuit breaker on?
-Is GFCI operating properly?
-Is the air switch plugged in?
-Jets should be pointed away from the suction inlet
so that air is not forced into pump suction
-Is the in-tub suction inlet blocked or covered?
-Is there any debris in the pump housing?
-Is there a leak in the piping or the pump?
-Is the proper voltage applied to the pump?
-Is there an extension cord being used?
10