GE Profile SPBD880 Manual Del Propietário página 7

The Instruction Panel
Press the tabs on the sides of the instruction
panel. Slowly rotate the instruction panel
toward you until it stops. Finally, slide the panel
down in front of the tanks into the slot
available.
Instruction panel
After adding laundry product, lift the panel
out of its resting position; then rotate the panel
closed until it snaps into its horizontal position.
NOTE: The drawer will not fully close
if the panel is in its open position.
The Detergent Tanks
To remove either of the two outer tanks,
grasp the sensor at the rear of the tank, using
the grip provided, and pull the sensor straight
up. Loosen the supply tube by rotating
1/4 turn the tube and fitting until the tube
can be pulled straight up.
Detergent tanks
• Each tank can hold 350 ounces of liquid
HE (High Efficiency) laundry detergent—
approximately 100 washes of regular
concentration detergent. The system
requires that at least 100 ounces of new
detergent must be added to the tank
to recognize that it has been filled.
• Detergent is pumped to the washer
at the beginning of the wash cycle.
The Fabric Softener Tank
To remove the center tank, grasp the sensor
at the rear of the tank, using the grip provided,
and pull the sensor straight up. Loosen the
supply tube by rotating 1/4 turn the tube and
fitting until the tube can be pulled straight up.
Fabric softener tank
Remove the tank by tilting slightly toward the
washer and pulling straight up.
• Each tank can hold 95 ounces of
concentrated liquid fabric softener, enough
for approximately 75 loads of concentrated
liquid fabric softener.
• Do not dilute with water.
• Do not put any other substance
into the tanks besides liquid
HE (High Efficiency) detergent.
• Do not fill the tank while it is removed from
the drawer.
• The SmartDispense ™ system determines
how much detergent to supply to the
washer, depending on the load size,
soil level and water hardness.
• Do not dilute with water.
NOTE: Use only
HE (High Efficiency)
detergent.
• If desired, concentrated liquid fabric softener
is pumped to the washer at the correct time
in the wash cycle.
• Do not put any other substance into the tank
besides concentrated liquid fabric softener.
• The SmartDispense ™ system determines
how much softener to supply to the washer,
depending on user inputs for the wash cycle.
NOTE: Use only concentrated liquid fabric
softener.
ge.com
7