GE Profile SPBD880 Manual Del Propietário página 11

Cleaning the SmartDispense
Detergent and Fabric Softener
Tanks:
Detergent and fabric softener may build up
in the bottom of the SmartDispense tanks
or on the fluid sensors. Residue should be
removed before refilling tanks.
1. Open the pedestal drawer to the maximum
possible distance.
2. Press the tabs on the sides of the
instruction panel. Slowly rotate the
instruction panel until it stops. Then, slide
the panel down in front of the tanks into
the slot available.
3. Select the tank that you wish to remove
for cleaning. Grasp the sensor at the rear
of the tank, using the grip provided, and
pull the sensor straight up.
4. Wipe the surface of the sensor, using
a moist cloth with a mild soap; then place
the sensor on the back surface of the
drawer or an adjacent tank.
5. Loosen the supply tube by rotating
the fitting 90° until the tube can be pulled
straight up.
6. Wipe the surface of the tube and place it
on the back surface of the drawer or an
adjacent tank.
Fitting
7. Remove the tank by tilting it slightly toward
the washer and pulling straight up.
8. Rinse the inside of the tank, using hot
water only to remove the residue.
9. Once the tank has been rinsed thoroughly,
replace the tank in the drawer before
refilling the tank.
10. Reattach the supply tube by inserting it
into the tank and tightening the fitting
by rotating toward the back.
11. Replace the sensor by inserting it into
the tank in its original position.
12. Open the tank cap and refill with
™
the desired detergent or fabric softener.
13. Close the information panel and the
pedestal drawer.
14. Adjust the setting in the SmartDispense
menu if any changes were made
to the concentration of the detergent
selected or to the location of the tank
that is being used.
ge.com
11