Install The Handle - Kohler K-T309 Guia De Instalacion

Long Stem
Extension
Small Bearing

5. Install the Handle

CAUTION: Risk of product damage to the K-306–KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove the sleeve from the handle assembly.
Set the sleeve into the center of the shroud with the screw holes
aligned.
Secure the sleeve with two screws.
If you have a thin wall installation, remove the large and small
bearings from the long stem extension.
Reinstall the large and small bearing and washers onto the short
stem extension.
Secure the chosen stem extension into the handle assembly with a
screw.
Thread the handle assembly over the sleeve, and securely hand
tighten.
1023642-2-C
Sleeve
Screws
Screw
Large Bearing
Short Stem Extension
Washers
Handle Assembly
8 Kohler Co.