Kohler K-704410 Manual Del Usuario página 10

Hanging Bracket
Blind Nut
Rollers on same side
as bottom frame hole.
7. Install the Hanging Brackets — Inside Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set unframed tempered glass directly on the floor.
Lay the inside door panel on a flat surface taking care to protect the glass. that the two holes located
in the bottom frame are in the up position.
Thread two provided # 8-18 x 3/8" panhead screws into the bottom frame approximately 1/4" (6
mm). Do not completely tighten at this time.
Insert a bushing into one of the holes at the top of the inside glass panel.
Install a hanging bracket over the glass panel, aligning the hole in the bracket with the bushing.
Repeat the steps to install the other bracket on the inside panel.
IMPORTANT! The steel side of the roller must be installed against the hanging brackets.
The inside panel is installed on the showerhead side of the bath or shower.
Install the rollers on the same side as the bottom frame holes.
Assemble the rollers and #8-32 x 3/8" machine screws to the hanging brackets through the center
hole of the bracket.
Secure the rollers.
1015439-2-D
Roller
Bushing
8-32 x 3/8" Machine Screw
Bolt
#8-18 x 3/8"
Panhead Screw
10
Install inside
panel roller.
Kohler Co.