Hozelock 4712 Manual Del Usuario página 6

Maintenance • Entretien • Wartung • Onderhoud • Mantenimiento • Underhåll • Vedlikehold • Huolto • Vedligehold
Manutenzione • Manutenção • Konserwacja • Συντήρηση • Bakım • Karbantartás • Zdr ba • Техническое обслуживание
Hooldamine • Tehniskā apkope • Priežiūra • Întreţinere • Обслуговування • Vzdrževanje
24
A
GB
Instructions & Warnings
• This sprayer is intended for use with water-based solutions
of: insecticides, fungicides, weedkillers & fertilizers.
• Always follow the chemical suppliers instructions, as well as
the instructions supplied with this sprayer.
Always wear protective clothing, goggles, face mask and
gloves.
Avoid inhaling spray mist.
Avoid skin contact with chemicals.
Always work in a well ventilated area.
Take care to protect children pets & fish from exposure to
chemicals.
Always wash hands thoroughly after use & especially
before eating.
Always wash any contaminated clothing.
Seek medical attention if spray gets in your eyes or you
develop any symptoms after spraying.
Do not spray near food or food preparation areas. When
spraying crops, pay particular attention to the chemical
manufacturers advice on time before crops can be eaten.
Do not spray any solvent e.g. White spirit.
Spray only thin watery solutions; thicker mixtures will clog
the nozzle.
Powdered chemicals can be sprayed successfully if they
are completely soluble in water. If they are not, or the
solution tends to settle, spraying can still be successful if
the mixture is continually agitated.
If the material to be sprayed contains sediment, strain the
liquid into the sprayer bottle.
Occasionally the pump will require lubrication.
First depressurise the system by squeezing the trigger.
25
G
A
A
26
G
B
C
D
Winter Use – drain liquid from all parts and prevent
damage from freezing.
Annual Maintenance – At least once per year thoroughly
clean the whole sprayer and apply silicone grease to all
moving parts & seals. Test with water, and if any washer or
seal has perished it must be replaced.
Make sure all nuts are screwed hand tight before use.
A
This sprayer is made from many different types of
B
plastic, and although the liquid you wish to spray may
be packed in plastic, this does not guarantee it will
not damage the sprayer. If you have any doubt about
compatibility contact Hozelock customer services. When
filling the sprayer ensure that the maximum fill level is not
exceeded.
Ensure that the pump is screwed into the bottle tightly.
C
If the sprayer has been used with chemicals, discard
D
safely any unused solution after use.
Fill sprayer with warm water (not hot), re-assemble the
E
sprayer and spray some of the contents. Repeat; check
that the nozzle is free from sediment. If necessary repeat
the process until the sprayer is clean. NB : Do not use
detergent.
Occasionally the pump will require lubrication.
F
First depressurise the system by squeezing the trigger.
The pump O-ring should be lubricated to allow the sprayer
G
to pump air efficiently. Apply silicone grease regularly, to
the pump O-Ring (A).
The nozzle cap (B) & swirl grooves (C) should be kept clean
H
and free of obstruction. The O-ring should be lubricated
to allow the spray pattern to be easily changed. Apply
silicone grease regularly, to the nozzle O-ring (D).
Keep the trigger clean and free from build up of sediment
I
and chemicals by regularly flushing after use. If necessary
remove and clean the filter in the trigger.
27
H
Notes
I