Kichler Starkk LED 42 Manual De Instrucciones página 8

HANGING THE FAN (continued)
Step 4. Loosen the two set screws and remove the clip and cross pin from the top
coupling of the motor body.Carefully feed the fan wires up through the downrod.
Thread the downrod onto the motor coupling until the cross pin holes are aligned.
Next, replace the cross pin and clip, and tighten both set screws. (Fig.8)
Step 5. Slip the coupling cover, canopy trim ring and canopy onto the downrod.
Carefully reinstall the hanger ball onto the downrod. Make sure the cross pin is
in the correct position and the set screws are tight and the wires are not twisted.
(Fig.9)
Step 6. Now lift the motor body into position and place the hanger ball into the
hanger bracket. Rotate until the "Check Tab" has dropped into the "Registration
Slot" and seats firmly. (Fig.10) The entire motor body should not rotate if this is
done correctly.
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling fan
during operation.
8 | KICHLER.COM
Cross Pin
Clip
Set Screw
Cross Pin
Set Screw
Fig. 8
Fig. 9
Hanger
Mounting
Ball
Bracket
Fig. 10
Clip
Motor Body
Canopy
Hanger Ball
Canopy Trim Ring
Coupling Cover
Motor Body
Registration Slot
Check Tab