THOMSON DS120ICD Instrucciones De Funcionamiento página 15

Setting the Clock
After the unit is plugged into a mains supply or following a mains power failure, the display will show
"0:00" on the LED display. The unit should be in standby mode to set the current clock.
1. Press the TIME/ALARM button; the digits for the display will blink.
2. Press the /
to confirm the hour setting.
3. The minute digits on the display will blink.
4. Press the /
confirm the minute setting.
Setting the Alarm
This unit can be used as an alarm clock, CD /USB/SD/FM is activated to play at a preset time.
1. Press to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press and hold the TIME/ALARM button in shutdown state; the display will flash ON to select
setting the alarm and the display will blink.
4. Press the ALARM button to confirm; the time display will blink.
5. Press the /
6. Press /
7. Press ALARM to confirm, and then press
ALARM to confirm.
8. The volume turns up from 0 to 20 gradually.
9. Press the TIME/ALARM button in shutdown state; the display will flash ON to select setting the
alarm, and the display will blink.
10. Press the /
Sleep Mode
Press and hold the SLEEP button; the display will blink. Press the button repeatedly until the display
shows the minute you want to set. You can set 10 to 90 minutes.
It blinks three times to confirm, and then returns to the previous interface. If you want to cancel the
sleep mode, press OFF. After blinking three times, sleep mode will cancel.
Play
Play a disc
1. Press SOURCE repeatedly to select DISC source.
2. Press the to open the CD tray, put on a disc with the printed side facing upward and press
again to close the CD tray.
3. Play starts automatically, if not, press
4. Press VOL+/VOL – to adjust the volume.
Pause / resume play
1. During play, press
2. During play, long press the
Skip to a track
For CD:
1. Press /
2. Press the VOL+/VOL – to adjust the volume.
For MP3 disc and USB/SD
1. Press /
2. Press the VOL+/VOL – to adjust the volume.
button repeatedly until the correct hour is set. Press the TIME/ALARM button
button repeatedly until the correct minute is set. Press the TIME/ALARM to
button repeatedly to set the hour. Press the TIME/ALARM button to confirm.
to set the minute.
button to select OFF to cancel the alarm.
to pause/resume play.
/
to select another track.
to select a track or a file.
/ to select CD /USB/SD/FM status. Press TIME/
.
button to fast forward/fast rewind.
- EN 5 -