Barrette BOM-34116407 Instrucciones De Instalación página 8

6.
a. Loosely assemble the stair bracket base and
cover and use it as a template to mark locations for
pre-drilling.
NOTE:
b. Place the stair bracket base on the post aligned
with the marks made in step 5 (Fig. 7) ensuring
that brackets are properly oriented.
c. Mark the two hole locations shown (Fig. 8) for
each bracket and pre-drill using a
d. Secure brackets to post using the non-painted
flat head 1
7.
a. Measure the length of the rail panel and cut the
top rail (sold separately) to match. Press down
on the top rail to ensure that it fits snugly onto
the panel (Fig. 9).
b. Align top stair bracket with the rail end only at
the top of the stairs (Fig. 9). Using the pre-drilled
holes as a guide, drill through the railing using a
⁄ " drill bit being careful not to drill through the
1
8
top of top rail. Do this for the top of the stairs
only (Fig. 10).
8.
a. Press top rail cap and end covers onto both
ends of the top rail. Slide top brackets in place
on the rail ends, ensuring that the top rail cap
and covers nest into the grooves of the brackets
(Fig. 11).
b. Align the bracket, panel and top rail. Drive two
(2) 1
pre-drilled holes locking the assembly together
at the top of the stair rail only.
9.
a. Press bottom brackets onto the bottom rails.
Slide all four (4) brackets into bracket bases
which are connected to the posts.
b. Slide bracket covers onto the bases and loosely
secure in place with provided hinge bolts (Fig. 12).
8
If base is centered without bracket cover,
rail will NOT be centered.
⁄ " screws provided
1
2
⁄ " painted pan head screws through the
5
8
⁄ " bit.
1
8
Pre-Drill
Stair Bracket
Base
Top Rail
Pre-drill
End Cover
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Bottom Rail