Barrette BOM-34116407 Instrucciones De Instalación página 10

3.
a. Temporarily assemble top and bottom level
angle brackets. Mounting brackets slide into
bracket base, bracket cover is aligned, and the
bracket is fastened together using the hinge bolt
provided (Fig. 3).
b. Align panel on desired angle and mark the top
rails (Fig. 4) and bottom rails (Fig. 5).
c. Repeat this on the other side of the panel. Label
the top of the rail panel to simplify installation.
4.
a. For the bottom rail only, add
end or post (Fig. 6) to the marks made on the
panel in step 3 (Fig. 5) and cut the panel at these
marks.
b. For the top rail, cut the panel directly on the
marks made in Step 3 (Fig. 4).
c. Cut the top rail to the same length.
5.
Assemble Railing Section:
Follow Step 2 from "RAIL INSTALLATION -
FOR SQUARE AND/OR SPIRAL BALUSTERS" on
Page 4.
6.
Install Support Block:
Pivot support block in place under the rail (Fig. 12).
NOTE:
Secure support block to the mounting surface
using 1
into place using plastic plug (Fig. 13).
10
⁄ " screw(s) provided and press cover
1
2
⁄ " (toward the rail
3
4
Top Bracket
Hinge Bolt
3/4"
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 12
Fig. 13