VDS POWER 1R0 Serie Manual Del Usuario página 7

GB
8. DOOR OPEN RELAY & DOOR CLOSED RELAY
Door open relay is activated when the control unit reaches the position adjusted by the encoder or when the open limit switch is activated.
Door closed relay is activated when the control unit reaches the position adjusted by the encoder or when the close limit switch is activated.
The relays have normally open output contacts, when it reaches the active position the contact closes. If desired the
reverse action must activate I6.
9. ENCODER RS 485 (KOSTAL)
With option 5 ON, the control unit can works with RS485 digital encoder.
Follow the next steps for encoder programmation:
Initial conditions:
- Door at rest.
- You must connect a push button for open on terminals 26-28 and a push button for close on terminals 26-27.
- OPTION 5 ON
Open and close push buttons, will used to adjust the door closed and open positions, during the programmation process.
Process:
- Press PROG button during 1,5 sec. PROG led remains ON.
- With CLOSE push button, adjust the door to close position.
- After adjusting push PROG button during 1,5 sec. PROG led will flash.
- With OPEN push button, adjust the door to open position. (DEAD MAN)
- After adjusting push PROG. during 1,5 sec.
- Flashing light output will activated.
- Press CLOSE push button.
- Control unit will activate the motor to door closed position (adjusted previously) and will exit from programmation process. PROG led OFF.
10. SLUICE FUNCTION
- Connect closed door relay
CLOSED
CONTROL
UNIT 1
11. VERSIONS
POWER 1R0
- POWER 1R0: Equipment with plastic
housing.
POWER 1R0
output to next control unit STOP input.
STOP
DOOR
15 16 25 26
CLOSE STOP
CONTROL
UNIT 2
15 16 25 26
CONTROL
CONTROL
UNIT 1 UNIT 2
- POWER K 1R0: Equipment with plastic box housing
and push buttons (frontal membrane).
3 - 4