Fanaway LD-48 FAN IN Manual Del Usuario página 13

Fanaway Industri Installation Instructions
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and get familiar with the buttons
and function of each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are active.
BUTTONS ON THE REMOTE
HI: Press the button to set fan running at High speed.
MED: Press the button to set fan running at Medium speed.
LOW: Press the button to set fan running at Low speed.
OFF: Press the button to turn OFF the fan.
: Press the button to turn ON/ OFF the light.
The remote has memory function. If the fan or light is turned off by
the isolating switch, it will memorise and recover the last status
when turned on next.
INSTALLATION OF THE REMOTE CONTROL HOLDER (Fig. 14)
1. Locate a suitable wall or surface to
fix the remote control wall holder.
2. Remove the screw cover and install
the holder using the 2 screws and
re-install the screw cover. (Fig.14a).
3. Slide the remote into the holder.
(Fig. 14b).
13 | P a g e
Fig. 14a
Fig. 13
Fig. 14b
V1.1 EU (11/2019)