Guide Bar Maintenance; Chain Sprocket; Troubleshooting Tips; Troubleshooting Table - SNOWJOE SUN JOE 24V-HCS-CT Manual Del Operador

Fig. 19
Cutting edge

Guide Bar Maintenance

When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to
lay over sideways
• bent guide bar
• cracked or broken rails
• spread rails
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
You can purchase replacement parts for your Sun Joe
24V-HCS-CT cordless pruning saw by ordering online at
sunjoe.com or, to order by phone, contact Snow Joe
Sun Joe customer service at 1-866-SNOWJOE
®
(1-866-766-9563).

Chain Sprocket

Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 20).
Do not mount a new chain with a worn sprocket or vice-versa.
Inspection tool
Depth
limiter
tooth
Depth limiter tooth
®
+
®
17
Fig. 20
Troubleshooting

Troubleshooting Tips

Most difficulties are easy to fix. Consult the troubleshooting
table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor
adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless pruning saw.

Troubleshooting Table

Problems Corrective Action
The saw
•
Make sure that the battery is inserted correctly
motor fails
•
Check charge status and recharge the battery
to start
•
Make sure that the battery is inserted correctly
The saw
stops during
•
Check charge status and recharge the battery
operation
•
The machine is overloaded
The saw
runs, but
•
the chain
The chain is too tight; re-tension.
speed is
low
Bar and
•
The chain tension is too tight; re-tension.
chain
running
•
The chain need to be lubricated: lubricate the
hot and
chain with the oil.
smoking
The saw
motor
•
The chain tension is too tight; re-tension.
runs, but
•
The guide bar or chain is damaged; inspect
the chain
and replace the damaged part.
is not
turning
< 0.5 mm