URBANGLIDE GLIDE SUV Manual Del Usuario página 8

Sound alerts:
1 beep: normal operation on ignition.
2 beeps: Calibration error or misplaced user's weight, go down, turn off and on again.
Calibrate the product
1. Switch off the product. A beep will sound to indicate that the product is off.
2. Align the surface of the two flat pedals.
3. Press and stay press the button On/Off.
4. The battery indicator lights up first, stay pressed until the Segway beeps once, then release the
button.
5. The product is calibrated.
Load the product
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, then plug the other end of the charger into the
product.
3. When the red indicator lights up on the charger, it means that the charging is done correctly, if it is
not the case, check that the line is connected correctly.
4. When the LED on the charger changes from red to green, the battery is fully charged. Stop
loading. Charge time too long could affect the life of the battery.
5