Electrolux TRIMKITSS1 Hoja De Instrucciones página 7

8. a. Position Right Hand Side Trim on cabinet trim
with bottom resting on the floor.
b. Drill the 1/8" (3 mm) pilot hole.
c. Run screw in all the way and then back out.
Remove side trim for later install. (See Figure 10).
Figure 10
Top Trim Install
(Single and Dual Installations)
NOTE: Step ladder required for installing top
trim components.
9. a. Remove outer hinge screw common on both
sides for a dual installation, (for a single
installation this screw is removed in Step 6.
Align the top trim and attach with a 3/8" socket.
Repeat for opposite side. (See Figure 11).
b. (Dual installation only) Install outer screws on
common mounting bracket, align top trim
and attach with 3/8" socket. (See Figure 12).
Figure 11
H
Figure 12
10. 75" (1905 mm) High Opening With Top Trim
H
11. 79" (2006 mm) High Opening With Louvered Top
©2013 Electrolux Home Products, Inc.
INSTRUCTION SHEET
(Single and Dual Installations)
a. Slide units into place. Adjust height so top trim
height reaches 75.09" (1907 mm). Center units
in opening and level. (See Step 12 for leveling
instructions) (See Figures 13 and 14).
b. Drill 1/8" (3 mm) pilot holes and fasten screws
with a Phillips driver to kitchen cabinets.
Figure 13
Figure 14
Trim (Single and Dual Installations)
a. Slide units into place. Adjust height so top trim
height reaches 79.09" (2009 mm). Center units
in opening and level. (See Figure 15)
b. Drill 1/8" pilot holes and fasten two (2) screws
per side with a Phillips driver to kitchen cabinets.
Figure 15
Instruction Sheet A00343901 11.04.13