Maintenance - Craftsman 919.167281 Manual Del Propietário

For replacement parts contact:
Customer Responsibilities
Check Safety Valve
Drain Tank
Air Filter
Air compressor pump intake
and exhaust valves
1- more frequent in dusty or humid conditions
cycles automatically when power
is on. When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool.
To ensure efficient operation and lon-
ger life of the air compressor, a rou-
tine maintenance schedule should be
prepared and followed. The following
routine maintenance schedule is
geared to a unit in a normal working
environment operating on a daily ba-
sis. If necessary, the schedule should
be modified to suit the conditions
under which your compressor is used.
The modifications will depend upon
the hours of operation and the work-
ing environment. Compressor units in
an extremely dirty and/or hostile
environment will require a greater
frequency of all maintenance checks.
NOTE: See Operation section for the
location of controls.
For replacement parts contact:

MAINTENANCE

Before
each
use
Risk of Unsafe
Operation. Unit
www.allpartsinc.com
Daily
Every
Every
or after
40
100
each
hours
hours
use
(1)
To Check Safety Valve
does not work properly, over-
pressurization may occur, causing
air tank rupture or an explosion.
1. Before starting compres-
sor, pull the ring on the safety valve
to make sure that the safety valve
operates freely. If the valve is stuck or
does not operate smoothly, it must
be replaced with the same type of
valve.
To Drain Tank
1. Set the On/Auto/Off lever to
"OFF" and unplug unit.
2. Pull the regulator knob out and
turn counterclockwise to set the
outlet pressure to zero.
3. Remove the air tool or accessory.
4. Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately 20
psi. Release safety valve ring.
5. Drain water from air tank by
opening drain valve (counter-
clockwise) on bottom of tank.
in the air tank. If not drained, water
will corrode and weaken the air tank
causing a risk of air tank rupture.
15 - ENG
www.allpartsinc.com
1-877-475-5660
Yearly
Risk of Bursting.
If the safety valve
Risk of Bursting.
Water will condense
A17893
1-877-475-5660