Dell OptiPlex 3080 Micro Manual De Servicio página 53

Steps
1. Align and lower the system board into the system until the connectors at the back of the system board align with the slots
on the chassis, and the screw holes on the system board align with the standoffs on the system.
2. Replace the two (M3x4) screws and three (6-32) screws to secure the system board to the chassis.
3. Align the slot on the hard drive caddy support with system board and place the hard drive caddy on the system board.
4. Replace the screw (6-32) to secure the hard drive caddy support to the system board.
Next steps
1. Install the processor.
2. Install the speaker.
3. Install the memory modules.
4. Install the heat sink.
5. Install the fan assembly.
6. Install the WLAN card.
7. Install the solid-state
8. Install the hard drive assembly.
9. Install the front bezel.
10. Install the side cover.
11. Follow the procedure in
drive.
after working inside your computer.
Desmontaje y reensamblaje 53