Starting A Cycle Wash; Changing The Program Mid-Cycle - Infiniton DIW-NB410 Manual De Instrucciones

Description
Program
Of Cycle
Prewash
Soak
NOTE:
EN 50242: This program is the test cycle. The information for comparability test in
accordance with EN 50242.

Starting A Cycle Wash

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page"Product fiche".
Make sure that the water supply is turned on to full pressure.
4. Open the door, Press the power button.
5. Choose a program, the response light will turn on. Then close the door, the
dishwasher will start its cycle.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop working,
you can open the door completely.
2. Press Program button more than three seconds the machine will be in stand by
state.
3. You can change the program to the desired cycle setting.
Running
Detergent
Time(min)
Pre/Main
3 sec
14
Energy
(Kwh)
15 0.02
Water
Rinse
(L)
Aid
3.5