Cequent Performance Products 76082 Instrucciones De Instalación página 4

1. REMOVE TAIL LIGHTS: Open trunk and
remove access panel to the taillights,
remove 3 flange nuts (m8 socket) each side.
Note: recommend removing tie down loop
on passenger side for additional clearance
(T40 torx bit). Remove taillight and
disconnect wiring.
3. FASCIA REMOVAL: Gently pull up from the rear wheel well trim panel each side, unclipping the tabs inside.
Work up to taillights and continue to gently remove along plastic taillight support. Using a small screwdriver or
trim tool push down on cleats between the fascia and tail lights as needed. Continue to remove along inside
bottom to the trunk, lifting fascia up from bottom as needed. Carefully pulling the fascia away from the vehicle.
If present disconnect any wiring harness or sensor from fascia. If present remove sensors from fascia by
opening the small square holders. Both sides. See figure 6. Move the fascia cover aside.
©2016 Cequent™ Performance Products, Inc. -
2. FASCIA REMOVAL: From under the vehicle remove 2 bolts (m10 socket) see figure 2 & 3. Remove 2 bolts (each
side)(m10 socket) under vehicle near wheel well. See figure 2. Remove 3 (each side) plastic rivet in wheel well. Use
small screw driver or plastic trim tool or pliers to remove the center pin, remove remaining body of rivet. Gently pull
wheel well trim from fascia enough to clear where rear fascia and side fascia meet. Remove 1 (each side) rivet under
the wheel well cover using the same technique see figure 4. Remove 1 (each side) (m8)screw located behind the
wheel well covering. See figure 5
6 FLANGE NUTS FOR
TAIL LIGHTS
8 PLASTIC RIVETS
6 SCREWS UNDER FASCIA
2 SCREWS UNDER WHEEL
WELL TRIM
Printed in Mexico
4. LOWER EXHAUST: Un-bolt the exhaust from
the bumper attachment using a 12 point 3/8"
socket. Both sides.
Sheet 4 of 18 76082NP 7-8-16 Rev. A