Team kalorik TKG VT 1020 Manual De Instrucciones página 13

Fax +32 2 359 95 50

INSTALLATION
 After removing the packing materials, check the integrity of the appliance; if you are unsure,
do not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene, nails, etc.) must be kept out the reach of children because they are potential
sources of danger. Note: any stickers or advertising material applied to the grille must be
removed before using the appliance.
 Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity, and that the electric plug is grounded. In the event of incompatibility
between the plug point and the plug of the appliance, have the plug replaced with q
suitable one by professionally qualified personnel, who will make sure that the section of the
wires of the outlet is suitable for the power drawn by the appliance. In general, the use of
adapters or extension cords is not recommended; if their use is necessary, they must conform
to existing safety standards and their current capacity (amperes) must not be less than the
maximum of the appliance.
 Before each use, check that the equipment is in good condition, that the power cord is not
damaged: if in doubt consult a qualified professional.
 The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
 Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
-
falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
-
make sure that the front is free of floating materials (dust, etc.).
 The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
 Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined
surface (the appliance could fall over).
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and support and protection grid.
If in doubt, have the appliance checked or assembled by a qualified professional person. For
assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
1. Insert rod (4) into the base (3) and counterweight (2), inserting it into its seat, and lock
it with the "L" screw and washer (1).
2. Extend the adjustable rod (6) to the desired height and secure by tightening the fixing
rod fastening screw (5).
3. Place the motor housing (11) on the adjustable column
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
13
Assembly page 13/33
TKG VT 1020 - 160301