Introduction And General Description - Telwin Defender 8 Manual Del Usuario

2. INTRODUCTION AND GENERAL DESCRIPTION

- This battery charger can be used to charge free electrolyte
lead acid batteries used on petrol and diesel engine
vehicles, motor cycles, boats etc. and is suitable for
charging sealed batteries.
- Accumulators rechargeable in accordance to the output
voltage available: 6V / 3 cells, 12V / 6 cells.
- This model is a battery charger with a 100V-240V 50/60Hz
single phase power supply, with electronically-controlled
constant current and voltage.
The charge current and voltage supplied by the appliance
follow the IU charge curve.
- Automatic detection of battery voltage (6V-12V).
- Standard equipment:
Cables with crocodile clips.
Cables fitted with eyelets.
3. DESCRIPTION OF THE BATTERY CHARGER
Control, adjustment and signalling devices.
- The charging current is 0.75A:
- CHARGE LED "
- FULL LED "
Attention: there is no polarity inversion signal.
4. INSTALLATION
POSITIONING THE BATTERY CHARGER
- While the battery charger is in operation make sure it is in a
stable position.
- Do not lift the battery charger using the power supply cable
or the charge cable.
CONNECTION TO POWER
- The battery charger should be connected only and
exclusively to a power source with the neutral lead
connected to earth.
Check that the net voltage is the same as the voltage of the
equipment.
- Check that the power supply is protected by systems as
fuses or automatic switches, sufficient to support the
maximum absorption of welding.
- If you put an extension to the primary cable, the diameter
must be the same, never inferior.
- The connection to the power has to be made using the
cable.
5. OPERATION
BEFORE CHARGING
NB: Before charging check that the capacity of the battery
(Ah) which is to be charged, is not inferior to that reported
on the data table. (C min).
": charging in progress.
": end of charging.
- 5 -