Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Fan Assembly (with downrod).
(cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging
hanging bracket tab
bracket and let hanging ball rest on the hanging
bracket. Turn the hanging ball slot until it lines up
hanging ball slot
with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury
or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to "Wiring" section for wiring diagram.
canopy
6. Fan Assembly (flushmount).
canopy cover
Remove canopy cover and set aside to reveal
6 holes. Notice that 3 of the holes are larger
canopy
than the others.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph.
If there are 6 screws in top of motor housing,
remove every other screw and lock washer.
pin
Remove pin and clip from motor housing
yoke. Thread wiring through canopy. Place
clip
canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of
yoke
motor housing. Insert the 3 screws and
3 lock washers that were removed (if there
were only 3 screws located in top of motor
motor housing
housing, these screws/lock washers will be
located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
motor
housing
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
hanging bracket tab
non-slotted holes on the rim of the canopy
to do so.)
canopy
page 5
Capítulos
Tabla de contenido
