Craftmade BLD42-LED-1 Guia De Instalacion página 5

5. Fan Assembly (with downrod).
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin. Then, slide
hanging ball off of downrod.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires -- this will keep the wires together when
threading them through the downrod.
diagram 2.]
Determine the length of downrod you wish to
use. Thread electrical wires through threaded end
of downrod and pull extra wire slack from the
upper end of the downrod.
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip previously removed.
Tighten yoke set screws and nuts securely.
to diagram 2.]
Slide canopy over downrod.
Thread wires through hanging ball and then slide
hanging ball over downrod -- the top of the
downrod should be noted as having a set screw
hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
[Refer to diagram 1.]
[Refer to
[Refer to diagram 2.]
[Refer
[Refer to diagram 3.]
set screw
diagram 1
electrical wiring
downrod
clip
diagram 2
electrical wiring
downrod
diagram 3
stop pin
diagram 4
page 4
stop pin
hanging ball
yoke set screw
and nut
pin
motor
housing
canopy
motor
housing
set screw hole
hanging ball