Product Specifications - Homewerks 3070-250-CH-B-WS Guia De Inicio Rapido

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6.8 LPM) at 80 PSI
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area
where new faucet will be
mounted.
2. Using thread sealant tape
(wrapped clockwise) or pipe joint
compound, cover all exposed
male threaded areas.
Position shower kit so controls
will be at a comfortable height
and handle assembly has a firm
solid surface (2 x 4, concrete
block) to mount to.
3. Determine if the water supply
is coming from above or below
the shower handle assembly. If
coming from above, proceed to
next step. If from below, use a
wrench to remove the diverter
plug in the shower handle
assembly. Wrap the threads in
PTFE tape or compound. Place
the plug in the opposite plug
opening (opposite the hanging
ears). Firmly tighten.
To use outside or with just one
water source (cold). Adapt water
supply to fit into cold water supply
side. Make sure hot water faucet
stays closed at all times.
WARNING: DO NOT use with
just a hot water hook up.
Serious scalding will occur.
www.homewerksww.com
1
2
3
HOT COLD
DIVERTER
PLUG
DIVERTER
SHOWER
PLUG
ARM
COLD
HOT
SPECIFICATIONS
Total weight of item: 1.706 lbs.
4. Slide soap holder over shower
arm. Make sure mounting tabs of
soap dish are pointing up
toward the bend in the shower
arm (pointing toward where
shower head will be).
Using supplied screws, attach
soap dish at desired height to
wall.
5. Thread base of shower arm onto
shower handle assembly. Twist
until tight, make sure shower
head section (bend in arm) is
pointing AWAY from mounting
ears on handle assembly.
Attach shower head to upper
shower arm in a clockwise
motion.
6. Using 1/2" male adapters, attach hot and cold water supply lines. Hot
should go on the LEFT side as you are looking at the handle assembly.
Turn on water at main valve.
Turn on shower and flush the hot and cold lines for 30 seconds to
remove debris.
Shut off shower and attach shower head.
7. Attach shower head to top of shower arm. Do not over tighten. Use a
cloth in the jaws of the wrench to protect the finish of the shower head.
8. Mount shower handle assembly to a solid surface by using anchors/
bolts/screws (not supplied) through mounting ears.
2
4
5
SHOWER
ARM