Cleaning the self-cleaning recharger
Beard trimmings may become attached to the cleaning tray of the
self-cleaning recharger. Follow the steps below to remove them.
We recommend doing this each time you change the detergent
cartridge.
1
2
• Do not pull hard on the rubber blade protector at the bottom of
the cleaning tray. The rubber may come off if you pull hard on it.
It is only necessary to pull it up slightly.
• Warning - Do not wash or apply water to the adaptor or self-
cleaning recharger. Failure to observe this may cause electric
shock or result in short circuits.
10
All manuals and user guides at all-guides.com
1. Be sure to remove the water
tank and the appliance plug
from the self-cleaning
recharger.
• Be careful not to spill the
cleaning liquid.
2. Gently wipe off any beard
trimmings attached to the
inside of the cleaning tray with
a cloth or tissue paper
dampened with water.
• Clean the corners and
uneven parts of the
cleaning tray with a cotton
swab dampened with water.
When the water does not drain from the cleaning
tray
Removing the built-in rechargeable battery
Remove the built-in rechargeable battery
before disposing of the shaver. Please
make sure that the battery is disposed of
at an officially designated location if there
is one. Do not dismantle or replace the
battery so that you can use the shaver
again. This could cause fire or an electric
shock. Replace it at an authorized service
center.
1. Disconnect the power cord from the shaver when removing the
battery.
2. Remove the bottom cover screw .
3. Remove the bottom cover .
4. Slide the slide panels and remove them.
5. Remove the housing clips .
6. Remove the six housing screws .
7. Remove the housing .
8. Lift the batteries and remove them.
Beard trimmings may clog the
drain at the bottom of the
cleaning tray.
In this case, you cannot clean
or dry the shaver.
Push the beard trimmings
down through the drain with a
tooth pick etc.
�
�
�
�
�
�
�
�